top graphics line

 
Electrical winch - 7,5 kW/10 HP
Electrical winch

Power:
7,5 kW/10 HP

Power supply:
3 x 400 VAC/50 Hz,
Optional 3 x 500 VAC/60 Hz.

The front is covered by a transparent protection shield. (Polycarbonate, 6 mm).
 

Frequency converter:

The speed of the winch is fully variable due to the frequency converter.
Details for 11 KWatt winch, wire guide, drum, etc.
Details:
 
A: Hand brake
B: Slip ring device (optional)
C: Emergency stop. 1 pc at each end         
D: 4 brackets for lifting the winch
E: Automatic wire guide
F: Ball bearing for spindle
G: Reinforced edge
H: Solid fastenings brackets (4 pcs).
I: 4 Guiding rolls for wire
J: Drum

 
Wire guide system

The spindle is driven by an electronically regulated spindle motor which can be programmed by a PC.
General:  
CTD Winch, 7,5 kW, with adjustable speed. All materials:
AISI304/316 stainless steel.		  
   
Electrical  
Power supply: 3 x 400 VAC, 50 Hz
Optional:
3 x 500 VAC/60 Hz
Speed regulation: Fully variable by a joy stick. Regulated by a frequency converter, ABB, 7,5 kW.
Manoeuvre box: AISI 304 stainless steel, 3 mm and ABS plastic.
Enclosure rating: IP 65
Control box: AISI 304 stainless steel, 2 mm.
Enclosure rating: IP 65
Emergency brakes: 3 pcs. Located at each end of winch + the manoeuvre box.
Motor  
Main motor Bonfiglioli 7,5 kW, with electro magnetic brake. 3 x 400 VAC/50 Hz. Rev.: 1440/min
Gear motor for cable guiding system Bonfiglioli, 24 VDC/200 W. Rev.: 1500/min. Worm gear, Bonfiglioli VF 49, ratio 18:1
Mechanical:  
Material AISI 304 stainless steel
Main rack: Square tube, 100 x 100 x 4 mm.
AISI 304 stainless steel
Side plates: AISI 304 stainless steel, 8 mm. Reinforced by adding tubes of 60 x 40 x 3 mm. (AISI 304).
Drum and disc brake: AISI 304 stainless steel, 8 mm.
Finish The drum and the disc brake: Electro polish.
Main rack: Painting RAL 5010
Drum: Outer diameter: 740 mm
Inner diameter: 460 mm (standard delivery).
Drum rev: 0 - 43 rev./min. Adjustable.
Drum capacity:  
Wire speed: Approx. 1,0 m/sec.
Angle gearbox Bonfiglioli type A503. Ratio 18:1
Tractive force: Inner layer:
460 mm (Empty drum): 1500 Nm
Brake system: 1. Disc brake made of AISI 316 stainless steel, 8 mm
2. Automatic motor brake
Ball bearings AISI 304 stainless steel flange ball bearings, 3 pcs ø30 mm.
Protection shield: Transparent polycarbonate, 6 mm
Weight, standard, without wire 600 kg
Dimensions, overall: L x W x H: 180 x 113 x 160 cm

Last rev. of this page: September 25th, 2008